Piezo Syteme Jena

piezoelectric objective-lens positioning system

• 100 µm adjustment range
• thread size W0.8x1/36" to M 27x0.75
• easy to fix on microscopes by Flex-Adapter
• very compact design
• parallelogram construction
• high resonant frequency
• for microobjectives of up to 300g mass
• "upside-down" version of MIPOS 100 PL is
  available for inverted microscopes
  
• positioning feed back system as an option
• MIPOS 100 UD is available for inverted microscopy
• MIPOS 100 PL can be used either ways for upright and for inverted microscopy
  

The MIPOS 100 was developed for fine adjustment of micro objectives and object lenses. The maximum motion is 100 µm. The resolution of MIPOS 100 is very high and, in practice, only limited by the voltage noise of the power supply.
A special integrated pre-load design results in the following advantages: - very small angular deviation - highly parallel large range of motion - high resonant frequency On the top and bottom side of MIPOS 100 all standard threads for Zeiss, Leica, Nikon, Olympus etc. available.

Mounting this system on the microscope is very easy - screw the Flex-Adapter thread ring into the microscope and mount the MIPOS 100 on this ring with a screw. Because of the small size, no other threads beside the MIPOS are blocked.
A special version enables to work in upside down (UD) position on inverted microscopes. These MIPOS systems special signed by "UD"
To avoid drift an hysteresis, the MIPOS also available with an integrated strain gauge measurement system "SG".

recommended controller for MIPOS 100....